[ Request information ]
Primoco One 150 seen head-on on a runway at dusk

Primoco One 150

A 150 kg fixed-wing UAV for long missions over land and sea. NATO STANAG 4703 certified since March 2025.

Technical parameters

Published figures for the One 150. Switch units for a nautical briefing.

Primoco One 150 technical parameters
Max take-off weight150kg
Payload1–30kg
Cruising speed120km/h
Maximum range1,200km
Endurance10h
Maximum altitude3,300m

Sensors and payloads

Up to 30 kg of payload, configured for the mission.

Optical

  • Electro-optical cameras up to 4K, 90x optical zoom
  • Thermal imaging
  • Multispectral sensors
  • Cameras above 150 MPix
  • LIDAR

Radio frequency

  • VHF and UHF analysers
  • SIGINT and ELINT detectors and interceptors
  • Geolocation
  • Mobile signal analysis
  • Calibration of ILS, VOR, DME, NDB, TACAN, PAPI

Military

  • Datalinks
  • Communication and navigation jammers
  • Deception systems
  • SAR radars with GMTI and MMTI modes
  • Epsilon 180 EO/MWIR camera

Ground control station

Communicates with the UAVs 24/7 within up to 200 km. Data goes in real time anywhere, encrypted with AES-256. Built into a commercial vehicle or fully demountable, with side-stick control since 2023.

Ground control station interior

Low signature

A quiet four-stroke, four-cylinder engine, an extremely low radar cross-section, a minimal infrared footprint and a small optical silhouette, with camouflage patterns on request.

Primoco One 150 on an airfield

Training and support

Pilot, instructor and test pilot courses, sensor operator and mechanic training. Worldwide service with spare parts packages, on-site mechanics and full operational support.

Training at Písek airport

Regulation

LUC under EU 2019/947, EMAR 21 DOA and POA approval, LUC 2.5 SAIL III and NATO STANAG 4703. Operations in dozens of countries, including flights over cities and in non-segregated airspace.

Primoco One 150 on display

Configure your One 150

Payload, ground station and training are specified per customer.

[ Request information ]